• Empty contents of container into spray tank, turning the container so that any product trapped in the handle is allowed to flow out. Once flow is down to a drip, allow the container to drain for an additional 30 seconds.
  
  
• Immediately begin rinsing procedures or the product may become difficult to remove.
  
  
• Fill the empty container 1/4 full of clean water.
  
  
• Replace the cap on the container. With the container opening facing left, shake the container left to right over a distance of four to six inches. Shake the container about twice per second for 30 seconds.
  
  
• Drain rinse water into spray tank as previously described.
  
  
• Fill the empty container 1/4 full of clean water a second time.
  
  
• Recap the container. With the opening of the container pointed towards the ground, shake the container as described before. Then drain the rinse water into the spray tank. |
  
  
• Finally, fill the empty container 1/4 full once more with clean water.
  
  
• Recap the container. With the container in the normal, upright position, shake the container as described before.
  
  
• Pour the rinse water into the spray tank.
  
  
• Carefully rinse and spray residue from the outside of the container.
  
  
• Carefully rinse cap over spray tank opening and then dispose of cap appropriately as regular solid waste.

 
For Triple Rinsing Drums

First read the procedures for triple-rinsing containers as they contain important information. The following modified procedures for rinsing drums may require two people.

• Empty drum to the lowest possible level.
• Fill drum with water to 25% of capacity. Replace and tighten bungs.
• Tip drum on to its side and roll it back and forth, ensuring at least one complete revolution,  for 30 seconds.
• Stand the drum on its end and tip it back and forth several times to rinse the corners.
• Turn the drum over on to its other end and repeat this procedure.
  Carefully empty the rinsate into the spray can.
• Repeat this procedure two more times.
• Carefully rinse cap over spray tank opening and then dispose of appropriately as regular solid waste.
• Puncture the base of the drum with a drill so that it cannot be reused.
• Store drums under cover where they will be protected from rain.